User manual

Chapter 4 Troubleshooting
4-1. Error Message and Corrective Actions
CL-S700/CL-S703/CL-S700R 4-4
Causes/Corrective Actions ERROR LED LCD
keys, turn on the power, and then perform
sensor adjustment.
For details, refer to 2-3-4 “(3) How to change the
settings in Factory mode” in Chapter 2.
Paper jam
• Remove the jammed media.
Flashing Error
Paper Jam
Head low resistance value abnormality
• Due to defective thermal element:
Printing quality will degrade.
Flashing Alarm
Head Check
Ribbon end
• Install a new ribbon.
Flashing Error
Ribbon End
Communication error
• Receiving buffer overrun error
Flashing Error
Serial Over Run
Communication error
• Parity error
Flashing Error
Serial Parity
Communication error
• Framing error
Flashing Error
Serial Framing
Cover open
• Close the printer cover.
Flashing Error
Cover Open
Auto-cutter abnormality (foreign object etc.)
• Jamming, etc.
Flashing Error
Cutter Fail
Rewinder cover open (CL-S700R only)
• Close the rewinder cover.
Flashing Error
Rewind Open
Rewinder full (CL-S700R only)
• Remove the wound media from the rewinder
flange.
Flashing Error
Rewind Full
Rewinder failure (CL-S700R only)
• Does not rewind, etc.
Flashing Error
Rewind Fail
Rewinder motor temperature abnormality
(CL-S700R only)
• Rewinding stops temporarily. Wait until the
motor gets cool.
Flashing Alarm
Rewinder Hot