User`s manual

ESC c 5 n
[Function] Enabling/Disabling the panel switches
[Code] <1B> H <63> H <35> H <n>
[Range] 0
£
n
£
255
[Outline] Selecting the FEED switch valid/invalid.
•"n" is valid only in the lowest bit (n0).
•"n" bit means the followings.
n0 Condition
0 FEED switch valid.
1 FEED switch invalid.
[Caution] When the panel switch is disabled with this command, the FEED switch is
disabled. Therefore, the paper cannot be fed by operating the FEED switch.
[Default] n = 0
[Sample Program]
LPRINT CHR$ (&H1B) ; "c5" ; CHR$ (0) ; ••••••• W h en enabling the FEED switch
LPRINT CHR$ (&H1B) ; "c5" ; CHR$ (1) ; ••••••• W h en disabling the FEED switch
ESC d n
[Function] Printing and feeding the paper by n lines
[Code] <1B> H <64> H <n>
[Range] 0
£
n
£
255
[Outline] Prints data in the buffer and feeds paper by "n" lines.
•Specified line does not remain.
•The beginning of the line is to be considered as the next printing start position.
[Caution] If [n
´
line feed width] exceeds approximately 1016 mm, this command feeds
paper by approximately 1016 mm (40 inches).
[Default] The initial value is not defined.
[Sample Program]
LPRINT "AAAAA"
LPRINT CHR$ (&H1B) ; "d" ; CHR$ (2) ;
LPRINT "AAAAA" ; CHR$ (&HA) ;
END
[Print Results]