User`s manual

ESC c 3 n

[Function] Selecting the paper near end sensor valid for a paper end signal output

[Code] <1B>H<63>H<33>H<n>

[Range] 0

255

[Outline] This command selects at which paper near end sensor a paper end signal should

be output. Each bit for "n" has the following meaning:

Value

Bit Position

0 Paper near end Disabled Enabled

7 Undefined

This printer can only select one kind of paper end detection, a paper-near-end

sensor. "n" is valid for the least significant bit (n0).

[Caution] This command is valid only for the parallel interface.

[Default] n = 0

[Sample Program]

LPRINT CHR$(&H1B);"c3";CHR$(0);

•••••••When outputting the paper-end signal at the paper end

LPRINT CHR$(&H1B);"c3";CHR$(1);

•••••••When outputting the paper-end signal at the paper near end

ESC c 4 n

[Function] Selecting the paper near end sensor valid for print stop

[Code] <1B>H<63>H<34>H<n>

[Range] 0

255

[Outline] This command selects at which paper near end sensor printing should be stopped.

Each bit for "n" has the following meaning:

Value

Bit Position

0 Paper near end Disabled Enabled

7 Undefined

This printer can only select one kind of paper-end detection, a paper-near-end

sensor. "n" is valid for the least significant bit (n0).

[Default] n = 0

[Sample Program]

LPRINT CHR$(&H1B);"c4";CHR$(0);

•••••••When stopping printing at the paper end

LPRINT CHR$(&H1B);"c4";CHR$(1);

•••••••When stopping printing at the paper near end