User`s manual

ESC L
[Function] Selecting Page mode
[Code] <1B>H<4C>H<n>
[Outline] Switches from Standard mode to Page mode.
[Caution] •This command is only effective if it entered at the beginning of a line.
•This command is not effective if it is entered when in Page mode.
•Standard mode is restored when printing specified by FF is finished or when
ESC S is issued.
•The character mapping start position will be the point specified by ESC T in the
print area specified by ESC W.
•The commands listed below, which have separate settings for Page mode and
Standard mode, are changed to the settings for Page mode use.
(1) Spacing setting: ESC SP
(2) Line feed width setting: ESC 2, ESC 3
•In Page mode, the following commands can only be set.
(1) ESC V Specifying/changing to 90
°
-right-turned characters.
(2) ESC a Aligning the characters.
(3) ESC { Specifying/canceling the inverted characters.
(4) GS L Setting the left margin.
(5) GW W Setting the print area width.
ESC @ restores Standard mode.
[See Also] "Page Mode" in Appendix 1
FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS S, GS ¥