User`s manual

ManualsBrandsCitizen ManualsComputer equipmentiDP-3221

R R

R K

K-

-O

T T

T C

ONN

NNNN

NNE

, ,

, P

WER C

ER CER C

ER CO

r r

r K

-O

t t

t C

s s

s o

f f

f D

r r

r K

-O

t t

t C

(1) Drawer kick-out drive signal

Outputs a pulse specified with ESC p. The status of SW (+) can be checked with pin 34 on the

parallel interface connector, or with the DLE EOT, GS a, and GS r commands through the

serial/parallel interface.

(2) Electrical characteristics

1) Drive voltage: 24 V DC

2) Drive current: 0.8 A at maximum (Within 510 ms)

3) Switch signal level: "L" = 0 to 0.5 V, "H" = 3 to 5 V

s s

s P

n n

n C

No. Signal Function

1 FG Frame Ground

2 DRAWER 1 Drawer 1 drive signal

3 DRSW Drawer switch input

4 VDR Drawer drive power

5 DRAWER 2 Drawer 2 drive signal

6 GND Common ground on the circuit

Connector used : TM5RJ3-66 (Hirose) or its equivalent

Applicable connector : TM3P-66P (Hirose) or its equivalent

: • No output is made while printing.

• The drawers 1 and 2 cannot be driven simultaneously.

• A solenoid used for the drawer should be of 36

or more. An output current

should be kept below 0.8 A. Use beyond this limit cannot be assured.

• This connector cannot be connected to a telephone line. Do not connect

other than the solenoid.

e e

e C