User`s manual

4
44
4.
..
.9
99
9O
OO
Op
pp
pe
ee
er
rr
ra
aa
at
tt
ti
ii
io
oo
on
n n
n P
PP
Pa
aa
an
nn
ne
ee
el
l l
l a
aa
an
nn
nd
d d
d D
DD
Di
ii
is
ss
sp
pp
pl
ll
la
aa
ay
y y
y o
oo
of
f f
f E
EE
Er
rr
rr
rr
ro
oo
or
rr
r
1. POWER lamp (Green)
Illuminated if the power is turned on. Also, flashes to indicate a memory error.
2. ERROR lamp (Red)
Indicates an error by illuminating or blinking the lamps.
Error POWER Lamp ERROR Lamp Reset
Memory check error
Quick blinking
ON Cannot be reset
Cover open ON ON Close the cover.
Head overheat ON
Automatically reset by a
temperature drop
Paper near end ON ON
Set a new paper roll after a
print stop.
Paper end ON ON Set a new paper roll.
Cutter motor lock ON
Quick + Slow
blinking
Eliminate a paper jam.
Macro execution wait ON
Slow blinking
Press the FEED switch.
<
<<
<E
EE
Er
rr
rr
rr
ro
oo
or
r r
r D
DD
De
ee
et
tt
ta
aa
ail
ilil
ils
ss
s>
>>
>
Cover open ----- Opening of the printer cover is detected by the printer cover open sensor.
The ERROR lamp is then lit and print operation is halted. Note that the
DIP switch may be set to allow paper feed while the printer cover is open.
Head overheat ----- If the temperature of the printing head rises (about 65
°
C or more), in
order to protect it against overheating, a printing head temperature
sensor will be activated to stop printing. If the temperature drops (about
60
°
C), printing will be automatically resumed.
Paper near end ----- When the paper roll reaches a set diameter, the ERROR lamp is lit by the
paper near end sensor located on the side of the roller part of the upper
cover. (See the function of the control codes ESC c3 and ESC c4 in
"PRINT CONTROL FUNCTION.")
Paper end ----- When the paper roll runs out, the paper sensor located in the paper path
near the printing head detects paper end and the ERROR lamp is lit,
resulting in halting printing. (See the function of the control codes ESC
c3 and ESC c4 in "PRINT CONTROL FUNCTION.") When paper is
inserted into the paper path, loading of the paper roll begins.