User`s manual

• Be sure to use the specified paper roll.

• Use of non-specified paper may not guarantee the print quality, printing head life, and so on.

• The printer cover is not detachable. Do not apply an excessive force beyond its stopping

position.

• Do not insert a ragged or dog-eared end of the paper roll, because it could result in a paper jam

or insertion error.

• Rewind the paper roll if the paper is slack. If there is too much slack in the paper roll, since

the paper roll is apart from the paper sensor, the printer may perform the operation described

in 6. and 7. in 4.4.2 "Manually Inserting the Paper."

• If the paper roll is skewed, pull the platen lever forward to correct its position.

• When the paper roll has been set in place, the end of the paper may be fed from the paper

outlet in a folded or creased condition. If the paper does not appear at the paper outlet, check

the end of the paper and set it in place again.

• Do not open the printer cover while printing.

• Holding or touching the paper roll during printing may result in a paper jam.

• When the auto cutter is used for full cutting, remove the cut paper before starting the next

print operation to prevent jamming.

w w

w t

o o

o R

e e

e R

g g

g P

r r

r R

1. Open the printer cover.

2. Pull both platen levers in the direction of the arrow. The platen roller is then separated from

the printing head and the paper may then be removed.

• When removing the paper (in either

the forward or reverse direction), pull

the platen levers in the direction of

the arrow.

Platen Lever