User`s manual

GS V m ......... (1)
GS V m n ... (2)
[Function] Cutting the paper
[Code] (1) <1D>H<56>H<m>
(2) <1D>H<56>H<m><n>
[Range] (1) 0
£
m
£
1, 48
£
m
£
49
(2) 65
£
m
£
66, 0
£
n
£
255
[Outline] Cuts the specified paper.
"m" means the following.
m
Meaning
0,48
Full cut
1,49
Partial cut (leaving a bridge area uncut)
65
Paper feed by "cut position + {n
´
basic calculation pitch}
´
and full
cut
66
Paper feed by "cut position + {n
´
basic calculation pitch}
´
and
partial cut (leaving a bridge area uncut)
[Caution] •In Standard mode, this command only works when it is entered at the beginning
of a line.
For (1):
•A partial cut (leaving a bridge area uncut) is executed.
For (2):
•If n = 0, the paper is fed to the cut position, and then cut. If n
¹
0, the paper is fed
by "n
´
basic calculation pitch" inches past the cut position, and then cut.
•The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic calculation pitch (y).
A fraction resulting from the calculation is corrected with the minimum pitch
of the mechanism, and the remainder is omitted.