Service manual

iDP-3221 Service Manual
–
15
–
CITIZEN
7. Removing the bottom plate from the chassis
(1) Remove the two screws (M3
´
8).
(2) Slide the bottom plate in the direction
¬
a little to remove it from the power connector
housing.
(3) Lift the bottom plate while turning it in the direction
-
. Then, the bottom plate comes
off the chassis.
8. Removing the Auto Cutter ACS-231 from the Chassis
(1) Remove the bottom plate.
(2) Remove the upper cover.
(3) Disconnect the connector of the auto cutter from the control board.
(4) Remove the two screws
(M2.6
´
6) and detach
the auto cutter by
lifting it upward.
Bottom Plate
Connecting Sections
Auto Cutter ACS-231