User`s manual

________________________________________________________
52
Top-of-Form Fine Adjustment
_________________________________________________________________
11. Replace the top cover. The transparent part of the cover rests
against the tractor unit.
12. Turn on the printer.
Top-of-Form Fine Adjustment
You never need to use the paper feed knob for setting the top-of-
form. You can make minute modifications to the top-of-form on
continuous or single sheets by following these steps:
Your top margin is usually set by your software, You shouldn't need
to change the top-of-form setting very often.
1. Load paper onto the push tractor or into the paper guide. If you
are using single sheets, the paper automatically advances to the
top-of-form, so skip the next step.
2. If you are using continuous paper, press the PARK/LOAD ▲
key to move the paper to the top-of-form position.
3. Press the ON LINE key to set the printer on line.
4. Press and hold the PARK/LOAD ▲ key or the LF/FF ▼ key for
two to three seconds. This step directly enters the function to
chance the top-of-form position. The PARK/LOAD and LF/FF
indicators blink to let you know you're in top-of-form fine
adjustment mode.
The variable top-of-form setting of zero is the factory setting,
which is approximately one inch from the edge of the paper to
the top of a normal height character.