User`s manual

________________________________________________________
44
Paper Parking
_________________________________________________________________
Occasionally, you may not want the paper to automatically advance
to the paper tear-off. You can turn off this feature by changing TEAR
OFF to OFF in the VuePrint menu.
Paper Tear-Off Adjustment
The paper tear-off position is adjusted at the factory for standard
continuous paper. When this is not suitable for the paper you're
using, adjust the tear-off position by doing the following:
1. Load your paper with the tractor in the push position.
2. Make certain that the MENU slide switch is in the ON LINE
position. Switch the printer off line.
3. Press the PARK/LOAD ▲ key to advance the paper to the tear
bar.
4. Hold the ON LINE and QUIET/SAVE keys for three seconds.
ThePARK/LOAD and LF/FF indicators blink. Release the keys.
5. To adjust the edge of the paper upward to the tear bar by 1/72”-
inch increments press the PARK/LOAD ▲ key. Pressing the
LF/FF ▼ key adjusts the paper downward in 1/72”
-inch
increments.
To save your adjustment, press the QUIET/SAVE key. This
setting remains in effect, even if you turn the printer off, until
you repeat this procedure to set a different tear-bar position.
Paper Parking
Paper parking is a convenient feature that allows you to
switch quickly between continuous-feed paper
and single
sheets. To use it, your continuous paper must be fed in through the
rear of the printer with the tractor in the push position. This feature
is disabled when the tractor
is in the pull position.
It works by backing the continuous paper out of the printer to
where it is no longer touching the platen. However, the paper
remains in the tractor feeders, ready to feed into the printer.