User`s manual

________________________________________________________
38
The Tractor Unit
_________________________________________________________________
Installing the Tractor in the Pull Position
When the tractor is mounted in the pull position, it pulls the
paper up from the bottom and sends it straight up past the
platen. Use the pull position when you need a straighter paper
path {as with labels}. Follow the instructions below to change
the tractor to the pull position.
1. Remove any paper from the tractor.
2. With your thumbs on the release tabs and you fingers on the
side of the printer, push the tractor rearward. The unit will
easily pop off the locating tabs.
3. Hold the tractor unit so the sprockets face toward you and
the round crossbar is above the square crossbar. Gently
lower the tractor into the printer until each end of the tractor
rests on the flats of the mounting brace.
4. Gently press the tractor down and slightly forward until the
tractor's notches engage the forward locating pins.
Figure 3-4. Removing and installing the tractor unit in the push position.