User`s manual

________________________________________________________
37
Chapter 3: Paper Handling
_________________________________________________________________
Continuous
Single-sheet
Multi-copy*
Labels
Envelopes**
Push
Push
Pull
Pull
Push
Rear
Top
Bottom
Bottom
Top
Front
Back
Front
Front
Back
0
0
+1 or +2
+1
+2 to +6
* To print on 4-part forms Set COPY MODE {on the STYLE menu} on.
** Set ENVELOPE {on the INSTALL menu} on.
When you load paper that is narrower than the capacity of the
printer, place the paper near the left side of the printer. The paper-
out sensor is about two inches from the left edge of the printer
and the paper needs to cover it for successful operation.
Installing the Tractor in the Push Position.
When the tractor is mounted in the push position, it holds the
edges of the continuous paper and pushes it under and around the
platen until the paper comes out the top. Follow the instructions
below to change the tractor to the push position.
1. Remove any paper from the tractor.
2. With your thumbs on the release tabs and your fingers on the
side of the printer, push the tractor rearward. The unit will
easily pop off the locating tabs.
3. Set the tractor unit down in the rear printer opening. The front
of the tractor edges should butt against the two locating pins
that point outward from the sides of the mounting brace.
4. Place your forefingers between the ends of the tractor and the
rear of the printer opening and press the tractor forward until
release tabs lock onto the locator pins.
Paper t
y
pe Tractor
position
Paper-
feed
method
Paper
select
lever
Paper
thickness
lever
Table 3-2. Pa
p
er handlin
g
summar
y
.