Service manual

PN 4237242C
3.4-4
INSTALLATION PROCEDURES
OPTIONAL TICKET PRINTERS
Figure 3.4-4 Printer Connections for Two Printers
7. If this is the initial installation of the Graphic Printer:
a. Load paper into the Graphic Printer.
b. Set the Printer’s configuration for MD II use. Refer to step 3 of the Connect the
Printer the Printer procedure under Heading 3.2, INITIAL SETUP.
8. Turn on the MD II and print the calibration factors from both Printers to verify that the
Printers and instrument are working together. Since no menu item will set up both
Printers at once, use the Printers one at a time as follows:
r For the Graphic Printer -
t Select
1 Full Page Report or 2 Split Page Report on the Report Format menu
t Set the A/B Switch Box to A.
r For the Ticket Printer -
t Select
3 Ticket Report on the Report Format menu
t Set the A/B Switch Box to B.
Note: The first time the Ticket Printer option is enabled, the instrument will request
that you insert the Ticket Key Disk. Once the Ticket Printer enable is recorded in
CMOS, it will not be requested again.
I/O
AB
TICKET
PRINTER
GRAPHIC
PRINTER
POWER
SUPPLY
7242052B
MD II
POWER LINE
CORD (AC DILUTER
TO ANALYZER)
25-PIN PARALLEL
CONNECTOR
SERIAL
PORT 2
AC
POWER
CABLE
CENTRONICS
PARALLEL
PRINTER
CABLE
SERIAL
PORT 1
A/B
SWITCH
BOX