Service manual

PN 4237242C
D.1-2
OPTIONAL PRINTERS
EPSON TM-290P SLIP PRINTER
DIP Switch SW1 Settings
Installation Procedure
See Epson TM-290P Slip Printer under Heading 3.4, OPTIONAL TICKET PRINTERS.
Printer Self-Test
1. Ensure the MD II power is on and the Printer power line cord is plugged in.
2. Press the RELEASE key on the Printer.
3. Insert a ticket in the Printer.
4. Unplug the Printer’s power line cord.
5. Press and hold down the FORWARD key. While holding the FORWARD key, plug in the
power line cord to initiate the self-test.
6. Press the RESET button to stop the self-test. The self-test stops after printing a specific
number of lines.
Table D.1-1 DIP Switch SW1 Position Settings
Positions/Settings
1 - OFF 2 - ON 3 - ON 4 - ON 5 - OFF 6 - OFF 7 - OFF 8 - OFF 9 - OFF 10 - OFF
ON =
Autofeed
International Character Sets - See
Table D.1-2
Not Used Not Used Not Used Not Used Not Used Not Used
Table D.1-2 DIP Switch SW1 Settings for International Character Sets
Country
Position Settings
SW1- 2SW1- 3SW1- 4
U.S.A. ON ON ON
France OFF ON ON
Germany ON OFF ON
U.K. OFF OFF ON
DenmarkONONOFF
Sweden OFF ON OFF
Italy ON OFF OFF
Spain OFF OFF OFF