Service manual

PN 4237242C

4.26-1

SERVICE AND REPAIR PROCEDURES

SWEEP-FLOW TUBING

4.26 SWEEP-FLOW TUBING

Tools/Supplies Needed

B #2 Phillips-head screwdriver

B Needle-nose pliers

B Small-side cutter

Removal

1. Open the lower chassis as directed in Heading 4.4.

2. Gain access to the aperture area by removing the Diluter Panel shield with door. The

shield is held in place with three captive thumbscrews.

3. Disconnect the sweep-flow tubing. One end is attached to port 1 of LV4 and the other is

attached to the RBC aperture sweep-flow fitting on the Diluter Panel (Figure 4.26-1).

ATTENTION: Do not remove the upper left and lower right screws. This will release the box

shield attached to the back of the Diluter Panel.

4. Remove the face plate covering the sweep-flow tubing spool that is held in place by two

Phillips-head screws, one lower left and one upper right (Figure 4.26-1).

5. Remove the sweep-flow spool with tubing (Figure 4.26-1). It is not attached.

Figure 4.26-1 Sweep-Flow Tubing

DILUTER PANEL

LV4

SWEEP-FLOW

TUBING

SPOOL

7242025A

FACE

PLATE