Service manual

PN 4237242C
xiv
CONTENTS
TABLES
2.1-1 Functions the Diluter Table Can Use,2.1-4
2.1-2 Aspiration Cycle,2.1-5
2.1-3 Power-Up Cycle,2.1-6
2.2-1 AT Power Supply Output Connectors,2.2-1
2.2-2 AC Power/Vacuum Relay Card Connectors and Line Input Ranges,2.2-6
2.2-3 Linear Power Supply Card Test Points,2.2-8
2.3-1 Diluter Panel Solenoids and Their Function,2.3-4
2.3-2 Peristaltic Pumps Location and Function,2.3-6
2.3-3 Flex Connect Card Connectors and LEDs,2.3-7
2.3-4 Solenoid Interconnect Card Connectors and LEDs,2.3-8
2.4-1 AT Motherboard Switch and Jumper Settings,2.4-1
2.4-2 URA Card Switch and Jumper Settings,2.4-6
2.4-3 DRA Card Output Connectors,2.4-7
2.4-4 DRA Card Jumper Settings,2.4-8
2.4-5 Motor/Solenoid Driver Card Input Connections,2.4-10
2.4-6 Motor/Solenoid Driver Card Output Connections,2.4-10
2.4-7 Motor/Solenoid Driver Card Test Points,2.4-11
2.4-8 Motor/Solenoid Driver Card Jumper Settings,2.4-11
2.5-1 Sensor Preamp Adapter Card Input Connections,2.5-1
2.5-2 Sensor Preamp Adapter Card Output Connections,2.5-2
2.5-3 Sensor Preamp Adapter Card Jumper Settings,2.5-2
2.5-4 Vacuum Sensor Card Test Points,2.5-6
2.5-5 SPAD Card Input Connections,2.5-9
2.6-1 Pinouts for Serial Ports,2.6-1
3.1-1 Space Requirements,3.1-1
3.1-2 Connectors’ Part Numbers and Line Input Ranges,3.1-2
6.1-1 DCNs and Descriptions for Schematics Included in This Manual,6.1-1
6.1-2 DCNs and Descriptions for Schematics Not Included in This Manual,6.1-1
7.1-1 Diluter Functions Menu Options,7.1-1
7.1-2 Service Menu Options,7.1-2
7.3-1 Service Diagnostic Cycle,7.3-1
7.4-1 Error Messages,7.4-1
8.1-1 Cables,8.1-1
8.1-2 Lower Chassis,8.1-2
8.1-3 Peripherals and Support,8.1-5
8.1-4 Upper Chassis,8.1-6
8.1-5 Miscellaneous Hardware,8.1-7
8.2-1 MD II, Lower Chassis, Left Side View (See Figure 8.2-1),8.2-1
8.2-2 MD II, Front View (See Figure 8.2-2),8.2-2
8.2-3 MD II, Top View into Lower Chassis (See Figure 8.2-3),8.2-3
8.2-4 MD II, Upper Chassis (See Figure 8.2-4),8.2-4
8.2-5 MD II, Back View (See Figure 8.2-5),8.2-5
8.2-6 Traverse Assembly (See Figure 8.2-6),8.2-7
8.2-7 Diluter Assembly (See Figure 8.2-7),8.2-9
8.2-8 Syringe Assembly (See Figure 8.2-8),8.2-11
8.2-9 Peristaltic Pump Assembly (See Figure 8.2-9),8.2-13
A.1-1 Calibration Factor Limits,A.1-1
A.1-2 Amplifier Noise Limits,A.1-1
C