Service manual

PN 4237242C
4.19-3
SERVICE AND REPAIR PROCEDURES
TRAVERSE DRIVE BELT
4
5. Make sure the belt is clamped on the same plane as the motor pulley (Figure 4.19-1). If it
is not, loosen the belt and reposition it.
6. Close the lower chassis and turn ON the instrument’s power.
Verification
Perform an SVP (Heading 5.1). While the system is cycling, view the belt from the right-hand
side to ensure there are no bends. Adjust if necessary by loosening the clamp and moving
the belt.
CAUTION
Risk of component damage. Clamping the belt clamp too far forward or backward produces a
bend during normal operation that prematurely wears the belt, traverse housing and traverse guide rod.
Tighten the belt clamp on the same plane as the motor pulley to avoid premature wear on the belt, traverse
housing and traverse guide rod.