Specifications

-
30
-
To enable coupon function,
check mark in "Print
Coupon".
Add ”Coupon” information
* To register the information of the coupon, press “Add”. “Add Coupon Information” dialogue shows up.
"Keyword", "Replacing Characters" and "Coupon Image" need to be registered on it as a set.
* Coupon information up to 10 can be registered. Coupon information has to be aligned in priority order.
Upper information in the list has higher priority and lower information has lower priority. The order can
be changed by “Up” and “Down”. Searching Keyword, "Replacing Characters and printing coupon image
are done in the priority order.
* The image data to use for coupon must be in black/white bitmap format and its width must be up to
1023 pixels.
* If "Keyword", "Replacing Characters" and "Coupon Image" are same, it cannot be registered. If any of
them is different, it is handled as new coupon information and can be registered.
Behavior of coupon printing
* First, characters to correspond with "Keyword" are searched in the print data. When the characters are
found, the coupon image data linked with the keyword is set to be printed at the end of print data. Then
corresponding characters are replaced by “Replacing Characters”
* If multiple coupon information exists, jobs are separated to “Coupon image printing” and “Character
replacing”.
* First, the routine of “Coupon image printing” is performed.
“Keyword” searching of first coupon information starts from top of print data. If the corresponding
characters are found, linked coupon image is printed at the end of printing. Then same routine is
repeated from 2nd coupon information to last coupon information. Then the routine of “Replacing
character” is performed. “Keyword” searching of first coupon information starts from top of print data.