Specifications

-
17
-
* As mentioned in section “4.1.2 NV Logo Process”, there are 2 different commands to register logo
data. Please make sure if the NV logo data is registered by FS q command or GS (L command.
Please refer to command reference for the details of the command.
* If “FS q” command is used, each logo data is recognized as follows.
logo1:Firstly registered NV logo
logo2:Secondly registered NV logo
logo3:Thirdly registered NV logo
logo4:Fourthly registered NV logo
logo5:Fifthly registered NV logo
* If “GS (L” command is used, the each logo data is recognized as follows.
logo1:NV logo saved as key code “L1”
logo2:NV logo saved as key code “L2”
logo3:NV logo saved as key code “L3”
logo4:NV logo saved as key code “L4”
logo5:NV logo saved as key code “L5”