Specifications

-
14
-
* Partial cut mean that cutter leaves one tab by the cut.
* This menu is not shown on the driver model where the cutter is not equipped.
* There is “Partial only” in the memory switch setting. If this setting is valid, “Full Cut” works only as
“Partial Cut” automatically. Please refer User’s manual for the details of memory switches.
4.1.7 Cash Drawer #1, #2
Setting of cash drawer 1/2
can be changed. Timing to
open drawer, pulse width to
send to drawer for opening
can be changed. For
timing, top of receipt (Job
Start), end of receipt (Job
End), end of page (Page
End) can be selected and
50ms to 250ms can be set
for pulse width.
Default setting are Drwer1
/ Job End / 50ms and
Drawe2 / Job End / 50ms.
*Cash drawer is the drawer to store bill, coin and etc at cash register.
* Driver model which does not have cash drawer function
* If the two cash drawers are connected to the printer, do not open 2 drawers at the same timing. It
may cause the printer malfunction.
* Pulse width for drawer opening is set for 50ms as default. Depending o the cash drawer type, this
setting may not open the cash drawer. Please adjust the pulse width according to the specification
of the drawer.
* Please refer to the User’s manual for the details to connect printer and cash drawer