Specifications

-
13
-
4.1.5 Paper Feed
Behavior and paper feeding
length can be set for end of
middle page (Page) and
end of last page (Job).
Feed Length (dot) :
It can be set from 0 to 406
dots.
Auto Feed to Cut Position :
Automatic paper feeding
for the cut can be set for
valid/invalid.
*If Auto Feed to Cut Position is set for valid and Feed Length is specified, paper feed to cut
position is done first then specified paper feed is performed.
4.1.6 Cutter Mode
Cutting method for middle
page end (Page) and
cutting method for receipt
end (Job) can be chosen.
For the normal paper, there
can be maximum 6
different cutting method
combinations by partial cut,
full cut and no cut.
For the label/black mark
paper, cut or no cut can be
chosen.
Default setting depends on
the driver.