Printer User Manual
Table Of Contents
- WEEE MARK
- Declaration of Conformity
- GENERAL PRECAUTIONS
- SAFETY PRECAUTIONS
- THE TABLE OF CONTENTS
- 1. GENERAL OUTLINE
- 2. EXPLANATION OF PRINTER PARTS
- 3. SETUP
- 3.1 Connecting the AC Power Cord
- 3.2 Connecting Interface Cables
- 3.3 Connecting the Cash Drawer
- 3.4 Precautions for Installing the Printer
- 3.5 Partition for Paper Roll
- 3.6 Setting the DIP Switch on the Serial Interface Board
- 3.7 Adjusting the Paper Near-end Sensor
- 3.8 Loading Paper
- 3.9 Attaching the Power Switch Cover
- 3.10 Attaching the Interface Cover
- 3.11 Removing the Interface Cover
- 4. MAINTENANCE AND TROUBLESHOOTING
- 5. OTHER
—37—
Use the paper shown in the following table or paper of the same quality.
(Unit: mm)
5.2 Printing Paper
Paper type Product name
Recommended
thermal roll
paper
TF50KS-E2D, TF50KS-E or TF60KS-E from Nippon Paper
PD150R or PD160R from Ohji Paper
PA220AG, HP220A, HP220AB-1, F230AA, P220AB, or PB670 (2-color paper) from
Mitsubishi Paper
CAUTION
Use thermal paper that is wound as follows:
Not creased and fits tight to the core.
Not folded.
Not glued to the core.
Rolled with the printable side out.
Paper width 83
+0
-1
Maximum print area 80
Maximum print area 72
Paper width 80
+0
-1
Printable side
φ80 or less
Paper width 58
+0
-1
Paper width 60
+0
-1
Maximum print area 48
(Initial setting)
Paper
thickness (μm)
65-75 75-85
Core inner
diameter d
(mm)
φ12 φ25.4
Core outer
diameter D
(mm)
φ18 φ32
Maximum print area 48
(Initial setting)