Printer User Manual
Table Of Contents
- WEEE MARK
- Declaration of Conformity
- GENERAL PRECAUTIONS
- SAFETY PRECAUTIONS
- THE TABLE OF CONTENTS
- 1. GENERAL OUTLINE
- 2. EXPLANATION OF PRINTER PARTS
- 3. SETUP
- 3.1 Connecting the AC Power Cord
- 3.2 Connecting Interface Cables
- 3.3 Connecting the Cash Drawer
- 3.4 Precautions for Installing the Printer
- 3.5 Partition for Paper Roll
- 3.6 Setting the DIP Switch on the Serial Interface Board
- 3.7 Adjusting the Paper Near-end Sensor
- 3.8 Loading Paper
- 3.9 Attaching the Power Switch Cover
- 3.10 Attaching the Interface Cover
- 3.11 Removing the Interface Cover
- 4. MAINTENANCE AND TROUBLESHOOTING
- 5. OTHER
—35—
The status display for various messages is shown below.
Notes:
*1: If the paper cover or front cover is open in standby.
*2: If the paper cover or front cover is open when printing or feeding paper.
*3: Buzzer sounds when MSW5-1 (buzzer setting) is set to ON.
Status
POWER LED
(green)
PAPER LED
(orange)
ERROR LED
(red)
Buzzer
*3
Paper near-end Lights Lights — —
Paper-end Lights Lights Lights Yes
Paper cover open or front
cover open
*1
Lights — Lights Yes
Paper cover open or front
cover open
*2
Lights — Yes
Cutter locked Lights — Yes
Memory error — — Yes
Print head hot Lights — Yes
Low-voltage error Lights — Yes
High-voltage error Lights — Yes
Waiting for macro to execute Lights — —