Printer User Manual
Table Of Contents
- WEEE MARK
- Declaration of Conformity
- GENERAL PRECAUTIONS
- SAFETY PRECAUTIONS
- THE TABLE OF CONTENTS
- 1. GENERAL OUTLINE
- 2. EXPLANATION OF PRINTER PARTS
- 3. SETUP
- 3.1 Connecting the AC Power Cord
- 3.2 Connecting Interface Cables
- 3.3 Connecting the Cash Drawer
- 3.4 Precautions for Installing the Printer
- 3.5 Partition for Paper Roll
- 3.6 Setting the DIP Switch on the Serial Interface Board
- 3.7 Adjusting the Paper Near-end Sensor
- 3.8 Loading Paper
- 3.9 Attaching the Power Switch Cover
- 3.10 Attaching the Interface Cover
- 3.11 Removing the Interface Cover
- 4. MAINTENANCE AND TROUBLESHOOTING
- 5. OTHER
—22—
This printer can only be positioned horizontally. It cannot be positioned
vertically or on a wall.
3.4 Precautions for Installing the Printer
CAUTION
Do not use the printer under the following conditions.
Locations subject to vibration or instability.
Locations that are very dirty or dusty.
Locations where the printer is not level.
• The printer may fall and cause an injury.
• The quality of printing may deteriorate.
Oriented other than as specified.
• The printer may malfunction, be damaged, or cause an electric shock.
Horizontal position
Vertical position