Service manual

CT-292/293 Series Service Manual
- 8 -
1-2-2. Disassembling “UNIT, MECHANISM”
1. Disassembling “SA, HOLDER PAPER”
Remove “SCREW, PHT (BT#3), M3.0 × 8”, that fasten “SA, FRAME BASE” and “SA, HOLDER PAPER”,
from the right and left sides, respectively.
<Precaution at reassembly>
Securely fit the bosses at “SA, HOLDER PAPER” into the slots at “SA, FRAME BASE”.
Remove “CUTTER CABLE” from the groove at “SA, HOLDER PAPER”, and draw it out from the hole.
Move “SA, HOLDER PAPER” along the groove at “SA, FRAME BASE” and remove it.
<Precaution at disassembly / reassembly>
Fit the boss at “FRONT DOOR ASSY” into the hole at “SA, HOLDER PAPER”.
Fit the boss in the following procedure.
SCREW, PHT (BT#3), M3.0 × 8
Remove the cable
from this groove.
Draw out “CUTTER CABLE”
from this hole.
Auto-cutter model (CT-P293) only
Fit the projection
at the gear here.
Fit the opposite
boss here.
Fit the boss into
the hole.
Fit the boss into
the hole.