Service manual

CT-292/293 Series Service Manual
- 9 -
<Precaution at disassembly / reassembly>
For the auto-cutter model, route the cable
outside the screw for “GUIDE, PAPER
ADJUST”, and insert it into the groove at “SA,
HOLDER PAPER” without any slack on the
cable.
Remove “PE, PCB ASSY” from “SA, HOLDER PAPER”.
Pull the hooks at the right and left outwardly, detach the lower lugs and pull “PE, PCB ASSY” upwardly to
remove it.
<Precaution at disassembly / reassembly>
When disassembling, do not pull the hooks excessively. Doing so may damage them.
When reassembling, insert “PE, PCB ASSY” while fitting the lugs first and then the hooks.
2. Disassembling “SA, FRONT DOOR ASSY”
Remove “E-RING, 2.0”, that fasten “SA, FRONT DOOR ASSY” and “SA, FRAME BASE”, from the right
and left sides.
Take up slack
from the cable.
Auto-cutter model (CT-P293) only
Insert the cable
into this groove.
Route the cable outside the screw.
SA, HOLDER PAPER
Hooks Hooks
PE, PCB ASSY
Lugs
Left Right