Specifications

— 8 —
3 Mounting on Rack
1. Insert the printer into the specified rack, etc. as shown in the following figure.
2. Attach the supplied mounting attachment to the printer from the rear and fix
the printer with the supplied screws.
3. After mounting, make sure the front cover can be opened and closed normally.
4. Apply appropriate force when tightening the screws while paying attention
to prevent deformed mounting attachment and printer case. Excessive
tightening may cause not only stress on the printer but also printer failure,
etc.
5. The mounting rack shall be about 1 to 3 mm thick.
CAUTION!
■ Screws for fixing mounting attachment must not be longer than 15 mm.
■ Install the printer with its front cover set vertical.
Mounting attachment
Rack
Printer
Front cover