Specifications

— 12 —
6 Setting DIP Switch
To set the DIP switch, the operation panel cover must be removed.
Remove the operation panel cover by using the following procedure.
1. Tu rn the printer power off.
2. Pressing the hooks at both sides remove the operation panel cover.
3. Set the DIP switch.
4. Return the operation panel to the former position.
(The printer does not operate if the operation panel is detached.)
Operation panel cover
Switch No. Function OFF ON
Switch No. Function OFF ON
CT-P290
Initial
Settings
1 Auto cutter Available - OFF
2 OFF
3 OFF
4 Spare Fixed - OFF
5 Spare Fixed - OFF
6 Print head installed - 2 inch ON
7 Character Normal Low current consumption OFF
8 Reserved Fixed - OFF
CT-P291
Initial
Settings
1 Auto cutter - Unavailable ON
2 OFF
3 OFF
4 Spare Fixed - OFF
5 Spare Fixed - OFF
6 Print head installed - 2 inch ON
7 Character Normal Low current consumption OFF
8 Reserved Fixed - OFF
Interface See Table below.
Interface See Table below.