Service manual

CMP-10 Service Manual
CMP-10 Rev. 1.00 P 4/41Date: 2002.07.25
2. GENERAL SPECIFICATIONS
Feature Parameters
1. Printing system Direct thermal printing
2. Printing speed 50 mm/sec
3. Printing head Total dots: 384
Dot density: 8 dots/mm
Printing width: 48 mm
4. Emulation ESC/POS commands + Unique commands
(with some unique functions)
5. Characters ASCII Code, Alphanumeric characters,
International characters, Windows Code page
6. Characters per line FONT A: 32 characters/line, FONT B: 42 characters/line
7. Dot matrix FONT A: 12H × 24V, FONT B: 19H × 16V
8. Bar code type UPC-A/E, JAN(EAN)13/8 columns, ITF, CODE39,
CODE128, CODABAR
9. Paper feed system Friction feed
10. Paper width 58 ±0.5 mm
11. Paper thickness 60 - 65 µm
12. Recommended paper TF50-KS-E2D (Nippon Paper)
13. Paper roll maximum diameter 40 mm (CMP-10-40), 50 mm (CMP-10-50)
14. Minimum core diameter 8 mm
15. Interfaces IrDA version 1.0
Serial interface (by special cable - option)
16. IrDA Interface Mode: Infrared transceiver mode
Transport wave: Wave length - 850 to 900 nm
Communication speed: 9600, 19200, 38400, 57600,
115200 bps
Data length: 8 bits
Start bit: 1 bit
Stop bit: 1 bit
Parity: none
Communication: Half duplex
Flow control: IrDA standard
Communication distance: Max. 80 cm
17. Serial interface Speed: 1200, 2400, 4800, 9600, 19200, 57600, 115200 bps
Interface: Bidirectional serial communication
Signal level: RS-232C
Data lenght: 8 bits
Start bit: 1 bit
Stop bit: 1 bit
Parity: None
Flow control: Xon/Xoff only
Connector: Motorola Star Tac
18. Input buffer 64 KB
19. Mag stripe reader Track 1, 2, 3
20. LED color Power LED: GREEN and RED
Charge LED: GREEN and RED