Troubleshooting guide

56
S50/S50a Head Pressure Adjustment
This setting is normally set at the factory for a 4 inch label width and may
need adjustment when other label widths are in use.
The Initial pressure should be set for the label width in use as indicated in
the chart below. Watch the Check Window, as the pressure adjustment
thumbscrew is being turned, until the slider is in the desired position. A
slight adjustment may be needed once this initial setting is made.
Print some label and check the right-to-left printing quality. Turn the Head
Pressure Adjustment Screw clockwise to darken the left side of the label or
counterclockwise to darken the right side of the label.