User`s manual

Printer Operation
40
2
Top Menu Sub Menu Default Menu Remarks
RS-232C Stop bit
[RS-232C Stopbit]
1 bit 1 bit
2 bits
Setting the stop bit for the serial interface.
RS-232C X-ON On Yes On Yes
ONo
Selectively setting the X-ON ow control of
the serial interface.
IEEE1284 On On
O
Setting both direction of the Centro Interface.
Web Monitor Auto Auto
On
O
Selecting the web monitor function.
Network Address 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed IP address of the LAN board.
Subnet Mask 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed subnet mask value of the LAN
board.
Gateway address 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed default gateway address of the
LAN board.
BOOTP O On
O
Setting the BOOTP of the LAN board.
DHCP O On
O
Setting the DHCP of the LAN board.
USB Device Class
[USB Device Clas]
Printer Printer
VCOM
Selects the USB device class.
USB VCOM Protocol
[VCOM Protocol]
Auto Auto
DTR
X-ON
Selects the protocol (ow control) when
operating USB VCOM.
Machine
Information
[Machine Info]
Model Number  CL-S*** Displays the model name.
Boot Version  *.* Displays the boot version.
ROM Version  ******** Displays the ROM version.
ROM Date  **/**/** Displays the date the ROM was prepared.
ROM CheckSum  **** Displays the check sum of the ROM.
Head Check  OK
NG
Displays the results of the head check.
Print Counter  ****.*** km Displays the print counter.
Service Counter  ****.*** km Displays the service counter.
Cut Counter   Displays the cut count.
Sensor Monitor  *.* V Displays the sensor level.
Option Interface
[Option I/F]
 None
LAN
Displays the presence/absence of the optional
interface.
Test Mode Print Pattern
Current Cong Current Cong
Global Cong
Sample
Executes the test pattern.
Head Check No Yes
No
Executes head check.
Factory Default No Yes
No
Initializes the set values of the conguration
set to the state when the unit was shipped
from the factory.
Hex Dump No Yes
No
Sets the hex dump mode.
Serial Monitor   Displays the state of the serial interface.
Auto Calibration
[Auto Cal]
See Through See Through
Reect
Executes the calibration of the sensor.
Sensor Monitor See Through See Through
Reect
Displays the level of the sensor.
Global
conguration
[Global Cong]
 Cong Set 1 Cong Set 1
Cong Set 2
Cong Set 3
Sets the Cong Set.
Note: To restore factory default settings, turn on printer power while pushing the MENU and PAUSE keys
simultaneously, then press the FEED key and the STOP key sequentially.
Mode Settings
[Zebra® Emulation]