User`s manual

Printer Operation
39
Mode Settings
[Zebra® Emulation]
Top Menu Sub Menu Default Menu Remarks
After Print AutoCongure
[Auto Cong]
On On
O
Automatically congures optional devices.
On.....AutoCongure enabled (Regardless
of whether Function Select is set, if a
peeler or cutter is installed, each mode
is set automatically.)
O ....AutoCongure disabled (A peeler of
cutter is installed, but to not operate
thepeelerorcutter,turnitOandthe
operation is selected by Function Select.)
Function Select
[Function Sel]
Tear O
Tear
Peel On*
Cut On**
Selects the operation when the
AutoCongureissettoO.Designatesthe
paper position based on each option. The
operation of this device is enabled during
selection. At the same time, the parameters of
the f command of Prodigy Plus are emulated
for each optional device.
Cutter Type Standard Standard
Heavy Duty
Selects the cutter type.
Standard: Model JN98901
Heavy Duty: Model JN98911
Cutter Action Backfeed Backfeed
Through
Sets the cutter action.
With the optional AutoCongure On, printing
is executed only when the cutter is installed or
only when Cut is selected by Function Select.
Backfeed is always set after cutting.
Through is set at the rear end of sheets 1 to
n-1 when the number of copies = n, and the
rear end of the nal page of single sheet and
the copy is backfeed.
Peel Wait Delay** 0.1 sec 0.1 to 2.0 sec Sets the Peel Wait Delay.
Displays only machines with a peeler installed.
Paper Position 0.00 inch
0.00 mm
Peel/Cut/TearO
0.00 to 2.00 inch
0.0 to 50.8 mm
Peel/Cut/Tear On
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Adjusts the stop position. It is based on the
inch/millimeter setting. There are initial values
of the stop position for each device set above,
and later, relative values are set.
Menu Key Action Enters Menu Enters Menu
Repeat Last One
Sets the menu key action.
Enters Menu:
Enters the menu setup mode.
Repeat Last One:
Last one is issued only for the nal page.
In the case of a count, afterwards, only
last one is issued.
Note: Hold down the MENU key for at least
4 seconds in order to enter the Menu Setup
Mode when setting the "Repeat Last One"
menu.
Interfaces RS-232C Baud 9600 115200
57600
38400
19200
9600
4800
2400
Setting the baud rate of the serial interface.
· All settings related to the interface are
enabled after the power is reconnected.
RS-232C Parity None None
Odd
Even
Setting the communication parity for the
serial interface.
RS-232C Length 8 bits 8 bits
7 bits
Setting the character length for the serial
interface.
* Only when peeling option is mounted.
** Only when cutter is mounted.