User`s manual

Printer Operation
36
2
Top Menu Sub Menu Default Menu Remarks
Menu Key Action Enters Menu Enters Menu
Repeat Last Set
Repeat Last One
Sets the menu key action.
Enters Menu:
Enters the menu setup mode.
Repeat Last Set:
Repeats the number of copies.
Repeat Last One:
Last one is issued only for the nal page.
In the case of a count, afterwards, only
last one is issued.
Note: Hold down the MENU key for at least
4 seconds in order to enter the Menu Setup
Mode when setting the "Repeat Last Set" or
"Repeat Last One" menus.
Interfaces RS-232C Baud 9600 115200
57600
38400
19200
9600
4800
2400
Setting the baud rate of the serial interface.
· All settings related to the interface are
enabled after the power is reconnected.
RS-232C Parity None None
Odd
Even
Setting the communication parity for the
serial interface.
RS-232C Length 8 bits 8 bits
7 bits
Setting the character length for the serial
interface.
RS-232C Stop bit
[RS-232C Stopbit]
1 bit 1 bit
2 bits
Setting the stop bit for the serial interface.
RS-232C X-ON On Yes On Yes
ONo
Selectively setting the X-ON ow control of
the serial interface.
IEEE1284 On On
O
Setting both direction of the Centro Interface.
Web Monitor Auto Auto
On
O
Selecting the web monitor function.
Network Address 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed IP address of the LAN board.
Subnet Mask 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed subnet mask value of the LAN
board.
Gateway address 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed default gateway address of the
LAN board.
BOOTP O On
O
Setting the BOOTP of the LAN board.
DHCP O On
O
Setting the DHCP of the LAN board.
USB Device Class
[USB Device Clas]
Printer Printer
VCOM
Selects the USB device class.
USB VCOM Protocol
[VCOM Protocol]
Auto Auto
DTR
X-ON
Selects the protocol (ow control) when
operating USB VCOM.
Machine
Information
[Machine Info]
Model Number  CL-S*** Displays the model name.
Boot Version  *.* Displays the boot version.
ROM Version  ******** Displays the ROM version.
ROM Date  **/**/** Displays the date the ROM was prepared.
ROM CheckSum  **** Displays the check sum of the ROM.
Head Check  OK
NG
Displays the results of the head check.
Print Counter  ****.*** km Displays the print counter.
Mode Settings
[Datamax® Emulation]