User`s manual

Printer Operation
25
Media Thickness Adjustment
(p.45)
Media Width Adjustment (p.46)
Setting the Media
Set the media roll and media holder in to the printer as shown 4.
above. It is advisable to pull a length of media forwards and
through the mechanism ready for later positioning.
Move the media roll so it is touching the left side of the 5.
housing. Then slide the black movable media guide so it is
touching the media on the right side.
Note: Do not try to hold the media too tightly with these guides as it will
cause the printer to jam during printing.
Align the media with the left fixed media guide (2 locations), 6.
align the right movable media guide with the media width, and
lower the damper arm which loosely holds the media in position.
Fixed media guide
Damper arm
Movable media
guide
Lower the head unit back down to the closed position. Push the 7.
head close knob rmly to close and lock the mechanism. The
mechanism is only locked correctly when you head a "click".
Align it with the width of the media that has been set, then set
the media width adjustment screw and the media thickness
adjustment knob. See "Chapter 3 Printer Adjustments".
Media width
adjustment knob
Media thickness
check window
Media thickness
adjustment screw
Media width check window
Head unit
With the power switched on, push the FEED key to feed the 8.
media. It will halt at the next print start position.