Service manual

3-38
CD-S500 Series
♦ Precaution when Mounting the Auto Cutter
• When mounting the auto cutter on the cutter chassis, fit the bosses into the corresponding holes
for positioning.
• Route the auto cutter cable as shown in the figure and tie down the cable with the cable tie.
♦ Precaution when Mounting Armature Switch 1
• When mounting armature switch 1 on the cutter chassis, check the orientation as shown in the
figure and fit the bosses into the corresponding holes for positioning.
Auto cutter
Armature switch 1
Cable tie
Auto cutter cable
Holes for
bosses
Bosses
Auto cutter
Holes for bosses
Bosses
Cutter chassis
* The above figure shows a rewinder model.