Service manual

3-37
CD-S500 Series
3-11-2 Disassembly and Assembly of Rewinder Model
The disassembly procedure is explained mainly. When assembling the parts, follow the disassembly
procedure in reverse.
♦ Removing the Auto Cutter
1) Remove screws A (2 pcs.), and remove the auto cutter from the cutter chassis.
* Use the positioning release slots (2 positions) and disengage the auto cutter when
removing the auto cutter.
* Cut the cable tie of the auto cutter cables and remove the auto cutter.
♦ Removing Armature Switch 1
1) Remove screw B (1 pc.), and remove armature switch 1 from the cutter chassis.
Screw B
Binding head screw M2 × 4
Screw A
Pan head screw M3 × 5 (S TITE)
Auto cutter
Armature switch 1
Cutter chassis
Cable tie
Auto cutter cable
Positioning release slot
* The above figure shows a rewinder model.