Service manual

3-36
CD-S500 Series
♦ Precaution when Mounting the Auto Cutter (Optional)
• When mounting the auto cutter on the auto cutter plate, fit the bosses into the corresponding
holes for positioning.
• Route the auto cutter cable as shown in the figure and tie down the cable with the cable tie.
♦ Precaution when Mounting the Auto Cutter Plate
• When mounting the auto cutter plate on the platen chassis, fit the bosses into the corresponding
holes for positioning.
Auto cutter (optional)
* With the standard model, a
dummy cutter is attached.
Platen chassis
Cable tie
Fit in the notch.
Auto cutter cable (optional)
Bosses
Holes for bosses
Bosses
Holes for bosses
Auto cutter plate
Auto cutter (optional)
* With the standard model, a
dummy cutter is attached.
* The above figure shows a standard model.