Service manual

3-35

CD-S500 Series

3-11 Disassembly and Assembly of the Auto Cutter

3-11-1 Disassembly and Assembly of Standard Model

The disassembly procedure is explained mainly. When assembling the parts, follow the disassembly

procedure in reverse.

♦ Removing the Auto Cutter (Optional)

1) Remove screws A (2 pcs.), and remove the auto cutter from the auto cutter plate.

* Use the positioning release slots (2 positions) and disengage the auto cutter when

removing the auto cutter.

* Cut the cable tie for the auto cutter cables and remove the auto cutter.

* With the standard model, a dummy cutter is attached to the auto cutter plate. If it is

necessary to remove the dummy cutter, remove it in the same way as the auto cutter.

♦ Removing the Auto Cutter Plate

1) Remove screws B (2 pcs.), and remove the auto cutter plate from the platen chassis.

* Use the positioning release slots (2 positions) and disengage the auto cutter plate when

removing the auto cutter plate.

Screw A

Pan head screw M3 × 5 (S TITE)

Auto cutter (optional)

* With the standard model, a

dummy cutter is attached.

Platen chassis

Screw B

Pan head screw M3 × 5 (S TITE)

Cable tie

Auto cutter cable (optional)

Auto cutter plate

Positioning release slot

* The above figure shows a standard model.