Service manual

3-34
CD-S500 Series
♦ Oiling to the Platen Chassis and the Cutter Chassis
When maintenance of the platen chassis or the cutter chassis has been performed, supply an adequate
amount of oil to the positions shown in the figure below. Use the type of oil specified in the figure.
For the oil type, refer to “3-13 Oiling” (Page 3-42).
Platen chassis
Gear of sector gear plate 1
(Oil type: MG-1)
SA1 PF shaft inserting hole
(inner surface)
(Oil type: MG-1)
Platen chassis
SA1 PF shaft outer surface at
the left end
(Oil type: MG-1)
Platen chassis shaft outer
surfaces at both ends
(Oil type: MG-1)
Platen chassis and
cutter chassis mounting surfaces
(Oil type: MG-1)
Cutter
chassis
Cutter chassis shaft outer
surfaces at both ends
(Oil type: MG-1)
* The above figure shows a rewinder model.