Service manual

3-33
CD-S500 Series
♦ Removing the Platen Cover
1) Remove screws A (binding head screw M2 × 4: 2 pcs.), and remove the platen cover from the
platen.
* The removing procedure of the platen cover is the same as is the case with the standard
model.
♦ Removing the Paper Guide
1) Remove screws A (screw M1.7 × 6 (#0) B TITE: 3 pcs.), and remove the paper guide from the
platen cover.
* The removing procedure of the paper guide is the same as is the case with the standard
model.
♦ Removing the Platen
1) Remove screws C (miniature pan head screw M3 × 6 W: 2 pcs.), and remove the platen from
the platen chassis.
* The removing procedure of the platen chassis is the same as is the case with the standard
model.
♦ Removing the SA1 PF Shaft
1) Remove the E ring (3.0: 1 pc.), and remove the SA1 PF shaft from the platen chassis.
* The removing procedure of the SA1 PF shaft is the same as is the case with the standard
model.
♦ Precaution when Mounting the SA1 PF Shaft
• When mounting the SA1 PF shaft on the platen chassis, supply oil to these parts.
Refer to “3-10-1 Disassembly and Assembly of Standard Model” and “♦ Removing the Platen
Cover” (Page 3-28).
CAUTION
• When removing the platen cover, be careful not to strain the paper guide. Otherwise,
the paper guide fixing area may be damaged.
Refer to “3-10-1 Disassembly and Assembly of Standard Model” and “♦ Removing the Paper
Guide” (Page 3-28).
Refer to “3-10-1 Disassembly and Assembly of Standard Model” and “♦ Removing the
Platen” (Page 3-28).
CAUTION
• When removing the platen, be careful not to strain the paper guide. Otherwise, the
paper guide fixing area may be damaged.
Refer to “3-10-1 Disassembly and Assembly of Standard Model” and “♦ Removing the SA1 PF
shaft” (Page 3-29).
Refer to “3-10-2 Disassembly and Assembly of Rewinder Model”“♦ Oiling to the Platen
Chassis and the Cutter Chassis” (Page 3-34).