Service manual

3-32
CD-S500 Series
♦ Precaution when Mounting the Sector Gear Plate 1
• When mounting sector gear plate 1 on the platen chassis, fit the bosses on sector gear plate 1
into the corresponding holes on the platen chassis.
• When mounting sector gear plate 1 on the platen chassis, supply oil to these parts.
♦ Precaution when Mounting the Platen Chassis
• When mounting the platen chassis on the base frame, supply oil to these parts.
♦ Precaution when Mounting the Cutter Chassis
• Mount the cutter chassis on the base frame, route the auto cutter cable as shown by the arrows
keeping the cutter chassis in the raised position, and then secure the cable with the cable holder.
When securing the cable, allow some leeway for the auto cutter cable.
• When mounting the cutter chassis on the base frame, supply oil to these parts.
Refer to “3-10-2 Disassembly and Assembly of Rewinder Model” and “♦ Oiling to the Platen
Chassis and the Cutter Chassis” (Page 3-34).
Refer to “3-10-2 Disassembly and Assembly of Rewinder Model” and “♦ Oiling to the Platen
Chassis and the Cutter Chassis” (Page 3-34).
Refer to “3-10-2 Disassembly and Assembly of Rewinder Model” and “♦ Oiling to the Platen
Chassis and the Cutter Chassis” (Page 3-34).
Keep some leeway for
routing the auto cutter cable.
Cutter chassis
Cable holder
Auto cutter cable
Auto cutter
Base frame
Platen chassis
Sector gear plate 1
Bosses
Holes for bosses
* The above figure shows a rewinder model.