Service manual

3-30
CD-S500 Series
♦ Oiling to the Platen Chassis
When maintenance of the platen chassis has been performed, supply an adequate amount of oil to the
positions shown in the figure below. Use the type of oil specified in the figure.
For the oil type, refer to “3-13 Oiling” (Page 3-42).
Platen chassis
Gears of sector gear plates 1 and 2
(Oil type: MG-1)
SA1 PF shaft inserting
hole (inner surface)
(Oil type: MG-1)
Platen chassis
SA1 PF shaft outer surface at
the left end
(Oil type: MG-1)
Platen chassis shaft outer surfaces at both ends
(Oil type: MG-1)
Platen chassis mounting surfaces
(Oil type: MG-1)
* The above figure shows a standard model.