Service manual

3-29
CD-S500 Series
♦ Removing Armature Switch 2
1) Remove screw A (1 pc.), and remove armature switch 2 from the platen chassis.
♦ Removing the SA1 PF shaft
1) Remove the E ring (1 pc.), and remove the SA1 PF shaft from the platen chassis.
* Slide the bearing and the SA1 PF shaft in the direction of the arrow when removing the
SA1 PF shaft.
♦ Precaution when Mounting Armature Switch 2
• When mounting armature switch 2 on the platen chassis, check the orientation as shown in the
figure and fit the boss into the corresponding hole for positioning.
♦ Precaution when Mounting the SA1 PF shaft
• When mounting the SA1 PF shaft on the platen chassis, supply oil to these parts.
SA1 PF shaft
Armature switch 2
Bosses
Holes for bosses
Armature switch 2
Screw A
Binding head screw M2 × 4
Bearing
E ring (3.0)
Platen chassis
* The above figure shows a standard model.
Refer to “3-10-1 Disassembly and Assembly of Standard Model” and “♦ Oiling to the Platen
Chassis” (Page 3-30).