Service manual

3-18
CD-S500 Series
♦ Removing the Cables
1) Remove all the cables from the connectors on the main PCB.
* The following cables are connected on the main PCB.
• Rear cover switch cable
• Front cover switch cable
• Paper near end sensor cable
• Rewinder motor cable (for rewinder model only)
• Main FFC
• Operation panel FFC
• Auto cutter cable (optional)
• Black mark sensor cable (optional)
Rear cover switch cable
Main FFC
Rewinder motor cable (For rewinder model only)
Auto cutter cable (optional)
Paper near end
sensor cable
* The above figure shows a standard model.
Main PCB
Front cover
switch cable
Black mark sensor cable (optional)
Operation panel FFC