Service manual

3-9
CD-S500 Series
♦ Removing the Rewinder Case (For Rewinder Model Only)
1) Remove screws A (4 pcs.) and screws B (2 pcs.), and remove the rewinder case from the base
frame.
* Pull the sides of the rewinder case outwards to disengage the bosses for positioning when
removing the rewinder case.
♦ Precaution when Mounting the Rewinder Case
• When mounting the rewinder case on the base frame, fit the hook on paper holder 3 into the slot
on the rewinder case and fit the bosses into the corresponding holes.
• Tighten the rewinder case together with the GND sheet.
Paper holder 3
Screw A
Binding head screw M3 × 5
Slot
Base frame
Bosses
GND sheet
Holes for bosses
Hook
Rewinder case
Screw B
Binding head screw
M3 × 8 (P TITE)
* The above figure shows a rewinder model.