Service manual

3-6
CD-S500 Series
3-5-2 Disassembly and Assembly of Rewinder Model
The disassembly procedure is explained mainly. When assembling the parts, follow the disassembly
procedure in reverse.
♦ Removing Rear Cover R and Window R
1) Slide knob R in the direction of the arrow and open rear cover R.
2) Remove screws A (2 pcs.), and remove rear cover R from the cutter chassis.
* Push the claws at rear cover R outwards when removing rear cover R.
3) Remove window R from rear cover R.
* Open the bottom (where the bosses are located) of rear cover R sufficiently when
removing rear cover R. If not opened sufficiently, the bosses may scratch the side face of
window R.
♦ Precaution when Mounting Window R
• When mounting window R on rear cover R, fit the bosses on rear cover R into the
corresponding holes on window R. Open the bottom (where the bosses are located) of rear
cover R sufficiently when mounting rear cover R. If not opened sufficiently, the bosses may
scratch the side face of window R.
Knob R
Rear cover R
Window R
Cutter chassis
Screw A
Binding head screw M3 × 8 (P TITE)
Boss
Hole for boss
Claws
* The above figure shows a rewinder model.