Service manual

6-20
CD-S500 Series
6-7-5 Drawer Check Mode
If the front cover is opened and then closed while P.OUT LED is flashing, POWER and P.OUT
LEDs stop flashing and remain lit and the printer goes to drawer check mode.
Check Item and Operation Method
6-7-6 Maintenance Sending/Receiving Mode
If the front cover is opened and then closed while POWER, P.OUT and ERROR LEDs flash
alternately, the printer goes to maintenance sending/receiving mode.
By using the maintenance application for CDñS500, it is possible to read/write the internal setting.
The mode ends through power-off.
No
No
Failed
ERROR LED lit
(POWER and P.OUT LEDs remain the same)
Drawer 1
check
No
No
No
Yes
No
Yes
Yes
Yes
No
Yes
No
Yes
Drawer 2
check
No
Yes
Start
POWER and P.OUT: Lit, ERROR: Off
Was FEED switch pressed?
Drawer condition check = Close?
Drawer condition check = Close?
Pulse output to drawer 2
Drawer condition check = Open?
Successful
P.OUT LED turns off
Was FEED switch pressed?
Pulse output to drawer 1
Drawer condition check = Open?
Successful
POWER LED turns off
Was FEED switch pressed?
3s elapsed?
3s elapsed?