Service manual

6-18
CD-S500 Series
* The total number of dots and running steps are read out from FROM to RAM when the printer
turns on and renewed at the time of printing or paper feed. When the printer is off, or if no data
is received for 3 minutes or longer, the values are saved in FROM. At the time of saving, if the
status is ONLINE, it becomes OFFLINE during data writing. For the following 6 items, equipped
functions vary depending on customers (factory option).
* The settings are adjusted before delivery at factory according to the required functions. These
settings are saved as the factory default and used as default when user initializes the printer
(returns the setting to the factory default).
(1) Paper Width
(2) Auto-Cutter
(3) Color Ribbon
(4) Take-Up Device
(5) Black Mark
(6) Power ON Info.
Note: If this mode is closed by opening and closing the cover, the setting of the
software switch will be initialized.
<Ment. Information>
FROM VER. -DP01-0000
FROM DATE -MM.DD.YY
BOOT DATE -MM.DD.YY
BK MARK - XXXX Crt.
Air Temp. - XXXX Crt.
Head Temp. - XXXX Crt.
Head Temp. - XXXX Max.
Head1 -XXXXXXXXX Dot
Head2 -XXXXXXXXX Dot
Head3 -XXXXXXXXX Dot
Head4 -XXXXXXXXX Dot
Head5 -XXXXXXXXX Dot
Head6 -XXXXXXXXX Dot
Head7 -XXXXXXXXX Dot
Head8 -XXXXXXXXX Dot
Head9 -XXXXXXXXX Dot
Feed -XXXXXXXXX Stp
Cutter -XXXXXXXXX Cut
Paper Width -76.2
Auto-Cutter -ON
Color Ribbon -ON
Take-Up Device -ON
Black Mark -OFF
Head Initialize -NO
Feed Initialize -NO
Cut Initialize -NO
Power ON Info. -NO
FROM version printing
Black Mark Adjustment value
Adjustment value of the current inside body temperature
Adjustment value of the current head temperature
Maximum detection temperature
Total number of printing dots of 1PIN
Total number of printing dots of 2PIN
Total number of printing dots of 3PIN
Total number of printing dots of 4PIN
Total number of printing dots of 5PIN
Total number of printing dots of 6PIN
Total number of printing dots of 7PIN
Total number of printing dots of 8PIN
Total number of printing dots of 9PIN
Number of running steps (by 24/144 unit)
Number of cutting times
76.2/69.5/57.5
OFF/ON (Cutter: Equipped/Not equipped)
OFF/ON (Color control: Valid/Invalid)
OFF/ON (Rewinder control: Valid/Invalid)
OFF/TOP/ BTM.F/BTM.R (Mark sensor: Valid/Invalid)
NO/YES (Reset of the total dot number of head pin:
Operated/Not operated)
NO/YES (Reset of the number of running steps:
Operated/Not operated)
NO/YES (Reset of the number of cutter cutting times:
Operated/Not operated)
NO/YES (Initial response at the time of start-up [3B, 31, 00]
Operated/Not operated)