Service manual

6-11
CD-S500 Series
* Changes are saved to FROM by opening and closing the front cover. After completion of
saving, remaining items are printed.
If the power is turned off before opening and closing the front cover, the setting change is invalid.
* If the paper runs out during the change, set the paper and close the rear cover to continue the
process.
The items of <InterfaceSW> in the printing example above are printed only with printers equipped with
an RS232C I/F PC board.
<Soft-Switch Setting>
Press Feed
→ Change PARM.
Press Feed For 2S
→ Next Item
F.Cover Open/Close
→ Save & Exit
<Soft Control-SW> - - - - - - - - - - - - - - - - -
Command Type -EPSON
Number of Col. -40/33
Font Select -7 × 9
Paper Plies -OFF
Paper End -ENB
Paper Near-End -ENB
Slashed Zero -OFF
Print Direct. -BI-DIR
Auto LF -OFF
Code Page -437
Buffer Size -4K
Init Signal -ENB
Buzzer -ON
<Interface-SW> - - - - - - - - - - - - - - - - - - -
Baud Rate -19200
Data Length -8bit
Parity Bit -NONE
Stop Bit -1bit
Protocol -DTR
<Mechanical-SW> - - - - - - - - - - - - - - - - -
Paper Width -76.2
Auto-Cutter -FREE
Color Ribbon -ON
Take-Up Device -ON
Title printing
EPSON/STAR/CBM1/CBM2
40/33, 42/35
9×9/7×9
OFF/2P/3P
ENB/DIS
ENB/DIS
OFF/ON
BI-DIR/UNI-DIR
OFF/ON
437/850/860/863/865/852/866/857/858/WPC
40/4K
ENB/DIS (RS232C 25PIN and Parallel 31PIN)
ON/OFF
1200/2400/4800/9600/19200
8bit/7bit
NONE/EVEN/ODD
1bit/2bit
DTR/XON-OFF
76.2/69.5/57.5
OFF/FREE/FULL/PAR.
OFF/ON
OFF/ON